Setting Static IP on Lane 3000 Devices

1.)  Connect Lane/3000 Ethernet cable to the back of the Ingenico Lane/3000 and into one of the LAN ports on your internet router.

Note: The make/model of your internet router and the Ethernet cables connected to it will look different than the one used to make this guide.

2.)  Connect Lane/3000 power supply to 120V power outlet and to the back of the Lane/3000 Ethernet cable.

Note: Lane/3000 will turn on once it’s connected to power.

3.)  Once the Lane/3000 is on, press 0-0-0-1, to access the Admin menu.

If the “Communication Type” is not set to Ethernet. Select “Communication type” > “Ethernet”. The Lane/3000 will ask you to reboot. Select Yes.

Admin Menu

4.)  Select “Ethernet Parameters”.

Ethernet Parameters

5.)  Select “IP Configuration”.

IP configuration

6.)  Select “DHCP activation”. Select “Off” then press “Enter (Green)” key.

 DHCP Off

DHCP Activation  

 7.)  Select “IP address”. Enter the static IP assigned to the device then press “Enter (Green)” key.

 Enter IP address

IP address  

8.)  Select “Subnet mask”. Enter the subnet mask of the LAN this device is connected to then press “Enter (Green)” key. (Unsure if this is necessary)

Subnet mask

Enter Subnet mask

9.)  Press “Cancel (Red)” key once.

10.)  Press “Enter (Green)” key when prompted to save changes.

11.)  Press “Cancel (Red)” key once. The device should reboot.