Provisioning Windows via Esper

Synopsis:

This article will go through the various steps to provision a new, Elo Windows, Lenovo or HP device. This article also assumes that a boot drive has been created already. If a boot drive has not been created, please create one via this article first:

https://getbite.zendesk.com/hc/en-us/articles/7009939430932 

You will also need a plug and play USB keyboard + mouse (or a combo device similar to the Logitech K400)

Step 1:

With the new drive in hand, plug in the usb drive into the Lenovo PC.  Get into the BIOS of the system by hitting F8 or F10 (after rebooting the system).  Note on HP devices - you need to hit escape then F9 or F10 to get to the proper menu.

Step 2:

Once in the BIOS it will look like this screen: 

Navigate to the Startup Tab. And select Primary Boot Sequence

Step 3:

Move the "USB HDD" Drive up to the top of the sequence by using the + key. Note you may have to use "shift" + "+" to trigger that symbol. 

Use "F10" to save. Note you may have to hold the "Fn" + "F10" to get F10 to read properly.

After saving the device will restart automatically.

Step 4:

On Bootup you will now see this screen which allows you to select which partition to edit:

Select the Hard Disk to install the OS there

Step 5:

After restarting it may turn to a screen to look like this:

Select "Install Esper Enhanced Android"

Step 6:

The terminal may restart automatically, or it may proceed to this next screen. If you see this screen, go to "UEFI Firmware Settings"

Step 7:

The device should boot back into the BIOS screen, and scroll back to the Startup Tab.

Promote Harddrive to the top priority (using the + key again).

Hit F10 to save and reboot.

The device should now boot into Esper.